Thinklogical Remote Power Distribution Unit 4/4 Manual User Manual download pdf (Page 7)

PDU 4/4 Product Manual September, 2014

Page 6

Front Panel LCD and Buttons

The front-panel LCD should be visible and accessible for system setup. The navigation buttons are used

to configure the unit and to review existing PDU 4/4 configurations.

Use the Up and Down Arrow Buttons to scroll through the Main Menus (Port Power, System). Once the

main menu choice is shown on the display, press the Enter Button. Use the Left and Right Arrow Buttons

to navigate through the menu options.

LCD Navigation Buttons

System Information and

Programming

The PDU 4/4 LCD menu is arranged as follows:

Display Modifiable Description

*Port Power

Port 1 Yes Display status of power on Port 1

Port 2 Yes Display status of power on Port 2

Port 3 Yes Display status of power on Port 3

Port 4 Yes Display status of power on Port 4

Port 5 Yes Display status of power on Port 5

Port 6 Yes Display status of power on Port 6

Port 7 Yes Display status of power on Port 7

Port 8 Yes Display status of power on Port 8

Display Modifiable Description

*System

DAISY Position No Location in DAISY Chain

Ctrl Rev No Revision of PDU

Offset Current (Tare)* Yes Calibrate current monitor on all ports.

Debug Values Yes Factory Debug Facility

*Offset Current (Tare) is only available from the front panel. This menu option sets a zero current reference and stores it

in non-volatile memory. To use this feature all ports must be off. Once the ports are off, set the Offset Current Tare to Yes,

it will revert back to No when the calibration is complete.

Convection Cooling

The PDU 4/4 does not require special cooling or ventilation other than what is normally provided in a standard

equipment rack. If mounted in an enclosed rack, the rack should have a ventilation fan to provide adequate

airflow through the unit(s).

Connecting the PDU 4/4

All physical connections to the product use industry-standard connectors. All connections are found at

the rear of the unit.

The rear panel consists of (2) AC Power Cords, (2) Circuit Breakers, (8) AC Power Outlets, (8) Port Status

LEDs, (1) USB Firmware Upgrade Port and (2) RJ45 Console Ports.

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

No comments

Thinklogical Remote Power Distribution Unit 4/4 Manual User Manual Page 7